Accessory Drive Belts
ADJUSTMENT
DRIVE BELT ROUTINGS
INSPECTION
REMOVAL & INSTALLATION
The details are as follows :---
Its complete procedure with Diagram:----
Adjustment
Belt tension is automatically maintained by a spring-loaded tensioner. No adjustment is necessary.
Belt tension is automatically maintained by a spring-loaded tensioner. No adjustment is necessary.
Drive Belt Routings
Inspection
Inspect the drive belt for signs of glazing or cracking. A glazed belt will be perfectly smooth from slippage, while a good belt will have a slight texture of fabric visible. Cracks will usually start at the inner edge of the belt and run outward. All worn or damaged drive belts should be replaced immediately.
Inspect the drive belt for signs of glazing or cracking. A glazed belt will be perfectly smooth from slippage, while a good belt will have a slight texture of fabric visible. Cracks will usually start at the inner edge of the belt and run outward. All worn or damaged drive belts should be replaced immediately.
Removal & Installation
2.0L (VIN N) & 2.3L (VIN Z) Engine
- Before servicing the vehicle, refer to the Precautions section.
- With the vehicle in NEUTRAL, position it on a hoist.
- Remove the splash shield
- Rotate the accessory drive belt tensioner.
- Remove the accessory drive belt.
To install:
- Rotate the accessory drive belt tensioner.
- Route the drive belt.
- Slowly release the tensioner
- Reinstall the splash shield.
- Before servicing the vehicle, refer to the Precautions section.
- Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
- Raise the vehicle with the transaxle in NEUTRAL
- Remove the splash shield
- Lower the vehicle.
- Rotate the accessory drive belt tensioner using a 3/8-inch drive breaker bar.
- Remove the accessory drive belt.
To install:
- Rotate the accessory drive belt tensioner with a 3/8-inch drive breaker bar.
- Route the drive belt.
- Slowly release the tensioner
- Raise the vehicle with the transaxle in NEUTRAL.
- Reinstall the splash shield.
- Lower the vehicle.
- Reconnect the negative battery cable.
- Before servicing the vehicle, refer to the Precautions section.
- Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
- Raise the vehicle with the transaxle in NEUTRAL
- Remove the splash shield
- Rotate the accessory drive belt tensioner.
- Remove the accessory drive belt.
To install:
- Rotate the accessory drive belt tensioner.
- Route the drive belt.
- Slowly release the tensioner
- Reinstall the splash shield.
- Reconnect the negative battery cable.
This details will help.
Thanks.
Below is the master help link provided to go through belt routing diagram:---
Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models:---
Check the link below: ----
FOR MORE HELP GO TO: ---
No comments:
Post a Comment