@

max

Wednesday

How to Replace Heater Core on Ford Edge and Lincoln MKX?


The procedure is similar for both ford and Lincoln car models:-----

The heater core replacing procedure is as follows:----

Removal & Installation: ----

NOTE
If a heater core leak is suspected, the heater core must be pressure leak tested before it is removed from the vehicle.

  1. Remove the heater core and evaporator core housing.
  2. Remove the 6 floor duct screws and the floor duct.
  3. Remove the heater core tube dash panel seal.
  4. Remove the heater tube bracket screw and the heater tube bracket.
  5. Remove the 5 fresh air inlet duct screws and the fresh air inlet duct.
  6. Disconnect the wire harness from the plenum chamber.
  7. Remove the 7 lower facing plenum chamber screws.
  8. Orient the heater core and evaporator core housing with the plenum chamber upright.
  9. Remove the upper facing plenum chamber screw.
  10. Remove the 2 plenum chamber clips and remove the plenum chamber being careful not to allow the evaporator core to become dislodged from the installed position.
    NOTE
    Do not handle the heater core by the inlet and/or outlet tube to remove. Handling the heater core by the tubes may damage the joints and lead to failure of the heater core.
  11. Remove the heater core in the following sequence.
    1. Grasp the heater core by the core-side of the heater tube connections and partially remove it from the plenum chamber.
    2. Grasp the heater core by the top of the core and remove it from the plenum chamber.
      NOTE
      It is not necessary to carry out this step if the evaporator core has not become dislodged from the installed position during this procedure.
  12. If the evaporator core has been moved at any point during heater core removal, remove the evaporator core, verify that the drain seal is installed in the correct position and install the evaporator core in the correct position. 

    Click image to see an enlarged view
    Fig. Verifying the drain seal position
To install:
To install, reverse the removal procedure.


These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment

@