@

max

Tuesday

How to Replace Ignition Lock Cylinder on Ford?

The Ignition Lock Cylinder replacing details are as follows:----


Ignition Lock Cylinder
REMOVAL & INSTALLATION Instructions are as follows:---


  1. Disconnect the negative battery cable.
  2. Turn the ignition switch lock cylinder to the RUN position.
  3. Place a 0.125 inch (3.17mm) diameter wire pin or small drift punch through the hole in the steering column shroud under the ignition switch lock cylinder.
  4. Depress the retaining pin while pulling out on ignitions switch lock cylinder to remove it from the steering column housing. 

    image
    Fig. Removing the ignition lock cylinder
To install:
  1. Install ignition switch lock cylinder by turning it to the RUN position and depressing the retaining pin.
  2. Insert the ignition switch lock cylinder into the steering column housing.
  3. Make sure the ignition switch lock cylinder is fully seated and aligned in the interlocking washer before turning the key to the OFF position. This will permit the retaining pin of the ignition switch lock cylinder to extend into the hole of the steering column.
  4. Using the key, rotate the ignition switch lock cylinder to make sure of correct mechanical operation in all positions.
  5. Connect the negative battery cable.

This will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment

@